Basically, I’m building a home and getting it wired with Ethernet cabling. I didn’t want to get too much into the technical details, so I just provided the builders with locations where I want RJ45 ports, along with one spot where I just said “24-port patch panel” (the number of ports located elsewhere being 22.

I did some Googling and figured the patch panel should cost at most $150 in hardware costs (I found plenty of sub-$100 options, but a couple of more expensive ones and would not have been . I didn’t mention anything about needing a rack because I thought it would be something that could just go directly in the wall. (And then I could buy a switch and use it to connect pretty much all the ports from the patch panel to the router.)

The builder came back to me with an estimated cost of:

  • $465 for a server cabinet: SEVCBN -6RU – 66WM
  • $567 for a patch panel: NCO760242563
  • $148 install charge

They gave me specific model numbers for the patch panel and server cabinet, but I can’t find information about whether that’s the actual cost of them, because the costs are locked behind having an account with the B2B retailers.

Does their proposed patch panel costing about 4x what I was expecting actually seem likely to give any value? Is there are explanation for that cost?

Secondary question: is having a wall-mounted cabinet worthwhile? How will it work in terms of installing a switch and connecting from the patch panel to the switch?

Thanks!

  • doeknius_gloek@feddit.de
    2·
    11 months ago

    So the patch panel will end up connected through at the front instead of being flush with the wall? And the wires would just be run out of the wall through to the front of the panel?

    The cables would come out of your wall, go into the back of the network cabinet and would then be clicked into the patchpanel from behind. From the front of the cabinet you will just see RJ45 ports that you then can connect to your switch. The back of the patchpanel will look something like this.

    Out of interest, what’s the alternative? Is it that the cables would be hard wired directly into a particular port of the patch panel and not be movable?

    Exactly. The patchpanel would provide a board where you could patch your cables into (like this).

    Another thing I would recommend is having a “service loop”. That means leaving a bit of extra cable when exiting the wall in case you need it. Otherwise you might need to pull a whole new cable if something unforseen happens and that sucks.